Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1F-593    Battery Energy Control Module

for Preparation Click here


DESCRIPTION

The battery ECU transmits information on the IG2 voltage of the battery ECU to the HV control ECU via CAN communication.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1F
593
IG2 signal circuit of battery ECU malfunction
  1. Wire harness or connector
  2. Battery ECU

MONITOR DESCRIPTION

When the IG2 voltage of the battery ECU, which is transmitted while the power switch is ON (IG), is low, the HV control ECU determines that a wiring malfunction has occurred at the IG2 terminal of the battery ECU. When the HV control ECU detects the malfunction, it illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P0A1F (INF 593): IG2 signal malfunction
Required sensor / components
Battery ECU
Frequency of operation
Continuous
Duration
TOYOTA's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TOYOTA's intellectual property
Other conditions belong to TOYOTA's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


Following conditions are met:
(a) and (b)
(a) IG2 signal status at HV control ECU
ON
(b) IG2 signal status from battery ECU
OFF

COMPONENT OPERATING RANGE


Battery ECU
DTC P0A1F (INF 593) is not detected

WIRING DIAGRAM


A092097E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (BATTERY ECU - IGN FUSE)


    A092033E01
  1. Disconnect the B11 battery ECU connector.



    A092034E01
  1. Remove the IGN fuse from the driver side junction block.

  1. Measure the resistance between the wire harness side connectors.

    Standard resistance (Check for open):
    Tester Connection
    Specified Condition
    IG2 (B11-13) - IGN fuse (2)
    Below 1 Ω
    Standard resistance (Check for short):
    Tester Connection
    Specified Condition
    IG2 (B11-13) or IGN fuse (2) - Body ground
    10 kΩ or higher

    NOTICE:
    When taking a measurement with a tester, do not apply excessive force to the tester probe to avoid damaging the holder.

  1. Reinstall the IGN fuse.

  1. Reconnect the battery ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BATTERY ECU ASSEMBLY