Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1D-568    Hybrid Powertrain Control Module

DTC    P0A1D-569    Hybrid Powertrain Control Module

for Preparation Click here


DESCRIPTION

The HV control ECU performs self-checks to detect an internal operating malfunction in the ECU.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1D
568
569
HV control ECU internal error
  1. HV control ECU

MONITOR DESCRIPTION

The HV control ECU performs diagnostic monitoring to verify proper operation of internal and external ECU systems. In this diagnostics monitor, the HV control ECU checks the REF signal from the motor main ECU for errors.
If the HV control ECU detects an error in the REF signal, it will conclude that there is a malfunction in the motor main CPU, the REF signal or the HV control ECU. The HV control ECU illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P0A1D (INF 568 / 569):
Motor REF signal malfunction
Required sensor / components
Hybrid vehicle control ECU
Frequency of operation
Continuous
Duration
TOYOTA's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TOYOTA's intellectual property
Other conditions belong to TOYOTA's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


REF signal
Abnormal

COMPONENT OPERATING RANGE


Hybrid vehicle control ECU
DTC P0A1D (INF 568 / 569) is not detected

INSPECTION PROCEDURE

1.READ OUTPUT DTC (HV ECU)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    DTC P0A0F (INF 243), P0A40 (INF 500) or P0A41 (INF 245) for the motor resolver is output



YES
GO TO RELEVANT DTC CHART
NO

REPLACE HYBRID VEHICLE CONTROL ECU