Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A78-308    Drive Motor "A" Inverter Performance

for Preparation Click here


DESCRIPTION

The HV control ECU receives a collision signal from the center airbag sensor and the No. 1 circuit breaker sensor to determine that the vehicle has been damaged. Then, it cuts off the high-voltage system to ensure safety. If the HV control ECU receives the collision signal only from the center airbag sensor, it turns OFF the system main relay and the power switch. If the HV control ECU receives the collision signal only from the No. 1circuit breaker sensor, it turns only the system main relay OFF.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A78
308
Collision signal input from center airbag sensor or No. 1 circuit breaker sensor
  1. Supplemental restraint system
  2. No. 1 circuit breaker sensor

INSPECTION PROCEDURE

1.CHECK VEHICLE FOR ANY DAMAGE
  1. Check the vehicle for any damage.

    Result:
    The vehicle is damaged.



YES
REPAIR VEHICLE
NO


2.GO TO SUPPLEMENTAL RESTRAINT SYSTEM
  1. Troubleshoot the airbag system.

    Result:
    There is malfunction in the airbag system.



NO
REPLACE NO. 1 CIRCUIT BREAKER SENSOR
YES

REPAIR MALFUNCTIONING PARTS AND COMPONENTS