Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Entire Combination Meter does not Operate

for Preparation Click here


WIRING DIAGRAM


E125435E01


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (METER - BATTERY AND BODY GROUND)
I102401E01
  1. Disconnect the C10 meter connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    C10-21 - Body ground
    Always
    10 to 14 V
    C10-4 - Body ground
    Power switch ON (IG)
    C10-22 - Body ground

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    C10-14 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY