Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Seat Belt Warning Light for Passenger Seat does not Flash

for Preparation Click here


WIRING DIAGRAM


E127622E01


INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear the DTC (Click here).

  1. Check for DTC (Click here).

    Result :
    Result
    Proceed to
    DTC B1771 is not output
    A
    DTC B1771 is output
    B



B
GO TO OCCUPANT CLASSIFICATION SYSTEM
A


2.CHECK FRONT PASSENGER SEAT BELT WARNING LIGHT
I102401E01
  1. Disconnect the C10 meter connector.

  1. Using a service wire, connect the meter terminal 30 on the wire harness side and body ground.

  1. Check that the passenger seat belt warning light turns on.

    OK:
    Front passenger seat belt warning light turns on.



NG
Go to step 4
OK


3.CHECK WIRE HARNESS (METER - SENSOR)
I102543E01
  1. Disconnect the A18 sensor connector.

  1. Disconnect the C10 meter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A18-13 (PBEW) - C10-7
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY 

4.CHECK WIRE HARNESS (WARNING LIGHT - METER AND BATTERY)
I102542E01
  1. Disconnect the F11 warning light connector.

  1. Disconnect the C10 meter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    F11-4 (PBEW) - C10-30
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    F11-6 (IG+) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE FRONT PASSENGER SEAT BELT WARNING LIGHT