Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Driver Side Seat Belt Warning Light does not Operate

for Preparation Click here


WIRING DIAGRAM


E125461E01


INSPECTION PROCEDURE

1.INSPECT FRONT SEAT INNER BELT ASSEMBLY LH (BUCKLE SWITCH)
I040072E02
  1. Remove the front seat inner belt LH.

  1. Measure the resistance of the buckle switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Seat belt is unfastened
    Below 1 Ω
    Seat belt is fastened
    10 kΩ or higher



NG
REPLACE FRONT SEAT INNER BELT ASSEMBLY LH
OK


2.CHECK WIRE HARNESS (INNER BELT LH - METER AND BODY GROUND)
I040074E02
  1. Disconnect the B15 belt connector.

  1. Disconnect the C10 meter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    C10-6 - B15-2
    Below 1 Ω
    B15-1 - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY