Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the Techstream's Data List allows switch, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch ON (IG).

  3. Turn the Techstream ON.

  4. Enter the following menus:

    1. for Engine and ECT: Powertrain / Engine and ECT / Data List.

    2. for ABS/VSC/TRAC: Chassis / ABS/VSC/TRAC / Data List.

  5. Read the Data List according to the display on the tester.

    Engine and ECT 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Speed
    Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
    Almost the same as the actual vehicle speed (When driving)
    -
    Engine Speed
    Engine speed / Min.: 0 rpm, Max.: 16,383 rpm
    Almost the same as the actual engine speed (When engine is running)
    -
    Coolant Temp
    Coolant temperature / Min.: -40°C (-40°F), Max.: 140°C (284°F)
    After warming up: 80 to 100°C (176 to 212°F)
    If the value is "-40°C (-40°F)" or "140°C (284°F)", sensor circuit is open or shorted

    ABS/VSC/TRAC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    (FR/FL/RR/RL) Wheel Speed
    Vehicle speed / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual speed (When driving)
    -