Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK POWER WINDOW REGULATOR MASTER SWITCH

E124642E02

  1. Disconnect the P17 switch connector.

  2. Measure the voltage and resistance of the wire harness side connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    BDR (P17-11) - Body ground
    V - Body ground
    +B (BDR) power supply
    Always
    10 to 14 V
    BW (P17-7) - Body ground
    W - Body ground
    +B (BW) power supply
    Power switch ON (IG)
    10 to 14 V
    BW (P17-7) - Body ground
    W - Body ground
    +B (BW) power supply
    Power switch OFF
    Below 1 V
    E (P17-1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    L (P17-5) - Body ground
    LG - Body ground
    Door control switch door lock input
    Door control switch LOCK
    Below 1 Ω
    L (P17-5) - Body ground
    LG - Body ground
    Door control switch door lock input
    Door control switch OFF
    10 kΩ or higher
    UL (P17-8) - Body ground
    BR - Body ground
    Door control switch door unlock input
    Door control switch UNLOCK
    Below 1 Ω
    UL (P17-8) - Body ground
    BR - Body ground
    Door control switch door unlock input
    Door control switch OFF
    10 kΩ or higher
    If the result is not as specified, there may be a malfunction on the wire harness side.


CHECK DRIVER SIDE JUNCTION BLOCK (MAIN BODY ECU)

B079545E02

  1. Disconnect the 1A, 1B, 1D, 1E and 1H junction block connectors.

  2. Disconnect the B5 and B7 ECU connectors.

  3. Measure the voltage and resistance of the wire harness side connectors.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    ALTB (1B-1) - Body ground
    W - Body ground
    +B (power system, generator system) power supply
    Always
    10 to 14 V
    ECUB (1A-30) - Body ground
    R - Body ground
    +B (ECUB) power supply
    Always
    10 to 14 V
    GND (1E-17) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    KSW (1E-23) - Body ground*1
    KSW (1E-26) - Body ground*2
    Y - Body ground
    Key unlock warning switch input
    Key inserted
    Below 1 Ω
    KSW (1E-23) - Body ground*1
    KSW (1E-26) - Body ground*2
    Y - Body ground
    Key unlock warning switch input
    No key in key slot
    10 kΩ or higher
    L1 (1H-4) - Body ground
    LG - Body ground
    Door control switch (master switch and passenger side switch) lock input
    Door control switch (master switch or passenger side switch) LOCK
    Below 1 Ω
    L1 (1H-4) - Body ground
    LG - Body ground
    Door control switch (master switch and passenger side switch) lock input
    Door control switch (master switch or passenger side switch) OFF
    10 kΩ or higher
    L1 (1H-13) - Body ground
    B - Body ground
    Door control switch (master switch and passenger side switch) lock input
    Door control switch (master switch or passenger side switch) LOCK
    Below 1 Ω
    L1 (1H-13) - Body ground
    B - Body ground
    Door control switch (master switch and passenger side switch) lock input
    Door control switch (master switch or passenger side switch) OFF
    10 kΩ or higher
    UL1 (1H-5) - Body ground
    BR - Body ground
    Door control switch (master switch and passenger side switch) unlock input
    Door control switch (master switch or passenger side switch) UNLOCK
    Below 1 Ω
    UL1 (1H-5) - Body ground
    BR - Body ground
    Door control switch (master switch and passenger side switch) unlock input
    Door control switch (master switch or passenger side switch) OFF
    10 kΩ or higher
    UL1 (1H-14) - Body ground
    V - Body ground
    Door control switch (master switch and passenger side switch) unlock input
    Door control switch (master switch or passenger side switch) UNLOCK
    Below 1 Ω
    UL1 (1H-14) - Body ground
    V - Body ground
    Door control switch (master switch and passenger side switch) unlock input
    Door control switch (master switch or passenger side switch) OFF
    10 kΩ or higher
    L2 (1H-16) - Body ground
    L - Body ground
    Driver side door key-linked door lock input
    Driver side door key cylinder LOCK
    Below 1 Ω
    L2 (1H-16) - Body ground
    L - Body ground
    Driver side door key-linked door lock input
    Driver side door key cylinder OFF
    10 kΩ or higher
    UL3 (B7-9) - Body ground
    P - Body ground
    Driver side door key-linked door unlock input
    Driver side door key cylinder UNLOCK
    Below 1 Ω
    UL3 (B7-9) - Body ground
    P - Body ground
    Driver side door key-linked door unlock input
    Driver side door key cylinder OFF
    10 kΩ or higher
    LSWD (B7-25) - Body ground
    LG - Body ground
    Driver side door lock position switch input
    Driver side door LOCK
    Below 1 Ω
    LSWD (B7-25) - Body ground
    LG - Body ground
    Driver side door lock position switch input
    Driver side door UNLOCK
    10 kΩ or higher
    LSWP (B7-10) - Body ground
    Y - Body ground
    Passenger side door lock position switch input
    Passenger side door LOCK
    Below 1 Ω
    LSWP (B7-10) - Body ground
    Y - Body ground
    Passenger side door lock position switch input
    Passenger side door UNLOCK
    10 kΩ or higher
    LSWR (B5-10) - Body ground
    O - Body ground
    Rear doors lock position switch input
    Rear doors LOCK
    Below 1 Ω
    LSWR (B5-10) - Body ground
    O - Body ground
    Rear doors lock position switch input
    Rear doors UNLOCK
    10 kΩ or higher
    DCTY (1D-21) - Body ground
    V - Body ground
    Driver side courtesy switch input
    Driver side door open
    Below 1 Ω
    DCTY (1D-21) - Body ground
    V - Body ground
    Driver side courtesy switch input
    Driver side door closed
    10 kΩ or higher
    PCTY (1D-24) - Body ground
    BR - Body ground
    Passenger side courtesy switch input
    Passenger side door open
    Below 1 Ω
    PCTY (1D-24) - Body ground
    BR - Body ground
    Passenger side courtesy switch input
    Passenger side door closed
    10 kΩ or higher
    RCTY (1D-5) - Body ground
    R - Body ground
    Rear LH courtesy switch input
    Rear LH door open
    Below 1 Ω
    RCTY (1D-5) - Body ground
    R - Body ground
    Rear LH courtesy switch input
    Rear LH door closed
    10 kΩ or higher
    RCTY (1D-20) - Body ground
    R - Body ground
    Rear RH courtesy switch input
    Rear RH door open
    Below 1 Ω
    RCTY (1D-20) - Body ground
    R - Body ground
    Rear RH courtesy switch input
    Rear RH door closed
    10 kΩ or higher
    BCTY (1D-7) - Body ground
    R - Body ground
    Back door courtesy switch input
    Back door open
    Below 1 Ω
    BCTY (1D-7) - Body ground
    R - Body ground
    Back door courtesy switch input
    Back door closed
    10 kΩ or higher
    BDSU (B7-12) - Body ground
    P - Body ground
    Back door opener switch input
    Back door opener switch ON
    Below 1 Ω
    BDSU (B7-12) - Body ground
    P - Body ground
    Back door opener switch input
    Back door opener switch OFF
    10 kΩ or higher

    HINT:
    *1: w/ Smart key system
    *2: w/o Smart key system

    If the result is not as specified, there may be a malfunction on the wire harness side.

  4. Reconnect the 1A, 1B, 1D, 1E and 1H junction block connectors.

  5. Reconnect the B5 and B7 ECU connectors.

  6. Measure the voltage of the connectors.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    ACT+ (1H-8) - Body ground
    Y - Body ground
    Door lock motor LOCK drive output (driver side door)
    Door control switch (master switch or passenger side switch) or driver side door key cylinder
    OFF →
    LOCK →
    OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    ACT+ (1D-3) - Body ground
    Y - Body ground
    Door lock motor LOCK drive output (passenger side door)
    Door control switch (master switch or passenger side switch) or driver side door key cylinder
    OFF →
    LOCK →
    OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    ACT+ (1H-17) - Body ground
    Y - Body ground
    Door lock motor LOCK drive output (rear LH and rear RH side door)
    Door control switch (master switch or passenger side switch) or driver side door key cylinder
    OFF →
    LOCK →
    OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    ACTD (B7-5)) - Body ground
    G - Body ground
    Door lock motor UNLOCK drive output (driver side door)
    Door control switch (master switch or passenger side switch) or driver side door key cylinder
    OFF →
    UNLOCK →
    OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    ACT- (1H-9) - Body ground
    G - Body ground
    Door lock motor UNLOCK drive output (passenger side door)
    Door control switch (master switch or passenger side switch) or driver side door key cylinder
    OFF →
    UNLOCK →
    OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    ACT- (1D-4) - Body ground
    G - Body ground
    Door lock motor UNLOCK drive output (rear LH side door)
    Door control switch (master switch or passenger side switch) or driver side door key cylinder
    OFF →
    UNLOCK →
    OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    BACT (B7-1) - Body ground
    Y - Body ground
    Back door lock motor OPEN drive output
    Transmitter switch (back door)
    OFF →
    UNLOCK →
    OFF
    Below 1 V →
    10 to 14 V →
    Below 1 V
    If the result is not as specified, the junction block may have a malfunction.


CHECK TRANSPONDER KEY ECU

B126056E02

  1. Disconnect the T5 ECU connector.

  2. Measure the voltage and resistance of the wire harness side connectors.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    CPUB (T5-3) - Body ground
    L - Body ground
    +B (CPUB) power supply
    Always
    10 to 14 V
    GND (T5-22) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    IG (T5-4) - Body ground
    O - Body ground
    IG power supply
    Power switch ON (IG)
    10 to 14 V
    IG (T5-4) - Body ground
    O - Body ground
    IG power supply
    Power switch OFF
    Below 1 V
    ACC (T5-12) - Body ground
    P - Body ground
    ACC power supply
    Power switch ON (ACC)
    10 to 14 V
    ACC (T5-12) - Body ground
    P - Body ground
    ACC power supply
    Power switch OFF
    Below 1 V
    CUWS (T5-5) - Body ground
    B - Body ground
    Halfway switch input
    Key inserted
    Below 1 Ω
    CUWS (T5-5) - Body ground
    B - Body ground
    Halfway switch input
    No key in key slot
    10 kΩ or higher
    If the result is not as specified, there may be a malfunction on the wire harness side.