Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > Key Lock-in Prevention Function does not Work Properly (Manual Operation and Operation Interlocked with Key are Active)

for Preparation Click here


DESCRIPTION

To prevent the key from being locked in the vehicle, the door control relay prevents doors from being locked by monitoring 2 switches: 1) the unlock warning switch, which turns ON when the key is inserted into the key slot; and 2) the driver side courtesy light switch, which turns ON when the driver side door is opened.

WIRING DIAGRAM


B132161E02


INSPECTION PROCEDURE

1.READ VALUE OF TECHSTREAM (FRONT DOOR COURTESY LIGHT SWITCH LH)
  1. Check the Data List for proper function of the driver side door courtesy switch.

    Main Body ECU:

    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Dor Cty SW
    Driver side door courtesy switch signal / ON or OFF
    ON: Driver side door is open
    OFF: Driver side door is closed
    -

    OK:
    ON (driver side door is open) appears on the screen.



OK
Go to step 4
NG


2.INSPECT FRONT DOOR COURTESY LIGHT SWITCH LH
B058556E16
  1. Remove the front door courtesy light switch.

  1. Measure the resistance of the switch

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Body ground
    Not pushed (ON)
    Below 1 Ω
    Pushed (OFF)
    10 kΩ or higher



NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH LH
OK


3.CHECK WIRE HARNESS (SWITCH - DRIVER SIDE JUNCTION BLOCK AND BODY GROUND)
B132162E01
  1. Disconnect the D7 switch connector.

  1. Disconnect the 1D junction block connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D7-1 - 1D-21 (DCTY)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.INSPECT KEY SLOT
B079242E01
  1. Measure the resistance of the key slot.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    2 - 4
    Key in key slot
    Below 1 Ω
    No key in key slot
    10 kΩ or higher



NG
REPLACE KEY SLOT
OK


5.CHECK WIRE HARNESS (SLOT - ECU)
B080183E01
  1. Disconnect the K2 key slot connector.

  1. Disconnect the T5 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    K2-4 (KSW1) - T5-5 (CUWS)
    Below 1 Ω
    K2-2 (COM) - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY