Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > All Doors LOCK / UNLOCK Functions do not Operate Via Master Switch

for Preparation Click here


DESCRIPTION

The body ECU in the driver side junction block receives switch signals from the power window regulator master switch and activates the door lock motors on each door according to the signal.

WIRING DIAGRAM


B131924E01


INSPECTION PROCEDURE

1.READ VALUE OF TECHSTREAM (DOOR CONTROL SWITCH)
  1. Check the Data List for proper functioning of the door control switch.

    Main Body ECU:

    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D/L SW-Lock
    Door control switch lock signal/ON or OFF
    ON: Door control switch is in LOCK position
    OFF: Door control switch is not in LOCK position
    -
    DL SW-Unlock
    Door control switch unlock signal / ON or OFF
    ON: Door control switch is in UNLOCK position
    OFF: Door control switch is not in UNLOCK position
    -

    OK:
    ON (door is locked/unlocked) appears on the screen.



OK
REPLACE DRIVER SIDE JUNCTION BLOCK
NG


2.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (DOOR CONTROL SWITCH)
B059539E17
  1. Measure the resistance of the door control switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 5
    Lock
    Below 1 Ω
    1 - 8
    Unlock
    1 - 5
    OFF
    10 kΩ or higher
    1 - 8



NG
REPLACE POWER WINDOW REGULATOR MASTER SWITCH
OK


3.CHECK WIRE HARNESS (MASTER SWITCH - DRIVER SIDE JUNCTION BLOCK AND BODY GROUND)
B079546E01
  1. Disconnect the P17 switch connector.

  1. Disconnect the 1H junction block connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    17-5 (L) - 1H-4 (L1)
    Below 1 Ω
    P17-8 (UL) - 1H-5 (UL1)
    P17-1 (E) - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE DRIVER SIDE JUNCTION BLOCK