Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > All Doors LOCK / UNLOCK Functions do not Operate Via Door Control Switch

for Preparation Click here


DESCRIPTION

The main body ECU in the driver side junction block receives switch signals from the door control switch and activates the door lock motors on each door according to the signals.

WIRING DIAGRAM


B131924E02


INSPECTION PROCEDURE

1.INSPECT DOOR CONTROL SWITCH
B071970E14
  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 - 6
    Lock
    Below 1 Ω
    3 - 5
    Unlock
    3 - 6
    OFF
    10 kΩ or higher
    3 - 5



NG
REPLACE DOOR CONTROL SWITCH
OK


2.CHECK WIRE HARNESS (SWITCH - DRIVER SIDE JUNCTION BLOCK AND BODY GROUND)
B079547E01
  1. Disconnect the D11 switch connector.

  1. Disconnect the 1H junction block connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D11-5 - 1H-14 (UL1)
    Below 1 Ω
    D11-6 - 1H-13 (L1)



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE DRIVER SIDE JUNCTION BLOCK