Home › BODY ELECTRICAL › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK DRIVER SIDE JUNCTION BLOCK

E122744E02

  1. Disconnect the 1A, 1B, 1D and 1E junction block connectors.

  2. Measure the resistance and voltage of the wire harness side connectors.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    ECUB (1A-30) - Body ground
    R - Body ground
    +B power supply
    Always
    10 to 14 V
    SIG (1B-1) - Body ground
    W - Body ground
    Ignition power supply
    Power switch OFF
    10 kΩ or higher
    Power switch ON (IG)
    Below 1 Ω
    GND (1E-17) - Body ground
    W - B Body ground
    Ground
    Ground
    Below 1 Ω
    KSW (1E-26) - Body ground
    Y - Body ground
    Halfway switch input
    No key in key slot
    10 kΩ or higher
    Key in key slot
    Below 1 Ω
    DTCY (1D-21) - Body ground
    V - Body ground
    Door courtesy switch input
    Driver side door CLOSED
    10 kΩ or higher
    Driver side door OPEN
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.


CHECK TRANSPONDER KEY ECU

E122745E01

  1. Disconnect the T5 ECU connector.

  2. Measure the voltage and resistance of the wire harness side connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    CPUB (T5-3) - Body ground
    L - Body ground
    IG power supply
    Always
    10 to 14 V
    ACC (T5-12) -Body ground
    P - Body ground
    ACC power supply
    Power switch OFF
    0 V
    Power switch ON (ACC)
    10 to 14 V
    GND (T5-22) - Body ground
    W-B -Body ground
    Ground
    Always
    Below 1 Ω
    CUWS (T5-5) - Body ground
    B - Body ground
    Halfway switch input
    No key in key slot
    10 kΩ or higher
    Key in key slot
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.