Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > ECU Power Source Circuit


DESCRIPTION

This circuit provides power to operate the main body ECU.

WIRING DIAGRAM


B189276E01


INSPECTION PROCEDURE

1.INSPECT FUSE (DOME)
  1. Remove the DOME fuse from the engine room junction block and relay block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (DRIVER SIDE JUNCTION BLOCK - BATTERY AND BODY GROUND)


  1. Disconnect the 1A and 1E junction block connectors.


    B126383E01

  1. Measure the resistance and voltage of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    1E-17 (GND) - Body ground
    Below 1 Ω

    Standard voltage:
    Tester Connection
    Specified Condition
    1A-30 (ECUB) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE