Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Ignition Switch Circuit


DESCRIPTION

When turning the power switch ON (IG), battery positive voltage is applied to terminal SIG of the main body ECU.

WIRING DIAGRAM


B126384E03


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-IG)
  1. Remove the ECU-IG fuse from the driver side junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.INSPECT IG1 RELAY


    A092673E27
  1. Remove the IG1 relay from the driver side junction block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    Below 1 Ω (when battery voltage is applied to terminals 1 and 2)



NG
REPLACE IG1 RELAY
OK


3.CHECK WIRE HARNESS (DRIVER SIDE JUNCTION BLOCK - BATTERY)


    B126385E01
  1. Disconnect the 1B junction block connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    1B-1 - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK WIRE HARNESS (DRIVER SIDE JUNCTION BLOCK - BODY GROUND)


    B126387E01
  1. Disconnect the 1E junction block connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    1E-17 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


5.CHECK POWER SOURCE CONTROL ECU (IG1D VOLTAGE)


    B126388E01
  1. Disconnect the 1J junction block connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    1J-3 - Body ground
    Power switch OFF
    Below 1 V
    Power switch ON (IG)
    10 to 14 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


6.CHECK WIRE HARNESS (DRIVER SIDE JUNCTION BLOCK - POWER SOURCE CONTROL ECU AND BODY GROUND)


    B126389E01
  1. Disconnect the 1J junction block connector.

  1. Disconnect the P6 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    1J-3 - P6-34 (IG1D)
    Below 1 Ω
    1J-3 or P6-34 (IG1D) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

GO TO SMART KEY SYSTEM (for Starting)