Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Engine Hood Courtesy Switch Circuit


DESCRIPTION

The engine hood courtesy switch is installed into the hood lock. This switch turns ON when the engine hood is opened and turns OFF when the engine hood is closed.

WIRING DIAGRAM


B189274E02


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (ENGINE HOOD COURTESY SWITCH)
  1. Check the Data List for proper functioning of the engine hood courtesy switch.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Hood Courtesy SW
    Engine hood courtesy switch signal / ON or OFF
    ON: Engine hood is open
    OFF: Engine hood is closed
    -

    OK:
    On tester screen, item changes between ON and OFF according to above chart.



OK
REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU)
NG


2.INSPECT ENGINE HOOD COURTESY SWITCH


    B117066E01
  1. Remove the courtesy switch from the hood lock.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Pushed (OFF)
    10 kΩ or higher
    Not pushed (ON)
    Below 1 Ω



NG
REPLACE ENGINE HOOD COURTESY SWITCH
OK


3.CHECK WIRE HARNESS (ENGINE HOOD COURTESY SWITCH - BODY GROUND)


    B126396E01
  1. Disconnect the E3 switch connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    E3-2 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK WIRE HARNESS (MAIN BODY ECU - ENGINE HOOD COURTESY SWITCH)


    B126397E01
  1. Disconnect the B6 ECU connector.

  1. Disconnect the E3 switch connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    B6-5 (HCTY) - E3-1
    Below 1 Ω
    B6-5 (HCTY) or E3-1 - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE