Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Security Horn Circuit


DESCRIPTION

When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU turns on the relay, causing the horns to sound at intervals of 0.4 seconds.

WIRING DIAGRAM


B189273E01


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (SECURITY HORN)
  1. Select the Active Test, use Techstream (with CAN VIM) to generate a command, and then check the security horn operation.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Horn
    Security horn
    ON/OFF
    -

    OK:
    Security horn sounds and stops.



OK
REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU)
NG


2.INSPECT SECURITY HORN


    B117055
  1. Remove the security horn.

  1. Apply battery voltage to the horn and check operation of the horn.

    OK:
    Tester Connection
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery positive (-) → Horn bracket
    Horn sounds



NG
REPLACE SECURITY HORN
OK


3.CHECK WIRE HARNESS (MAIN BODY ECU - SECURITY HORN)


    B126394E01
  1. Disconnect the B6 ECU connector.

  1. Disconnect the T1 horn connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    B6-1 (SEC) - T1-1
    Below 1 Ω
    B6-1 (SEC) or T1-1 - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU)