Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > DATA LIST / ACTIVE TEST



READ DATA LIST

HINT:
Using the Techstream's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

  1. Connect Techstream (with CAN VIM) to the DLC3.

  2. Turn the power switch ON (IG).

  3. Read the Data List according to the display on the tester.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Unlock Warning SW
    Key unlock warning switch signal / ON or OFF
    ON: Key is in key slot
    OFF: No key is in key slot
    -
    D Door Courtesy SW
    Driver door courtesy switch signal / ON or OFF
    ON: Driver side door is open
    OFF: Driver side door is closed
    -
    P Door Courtesy SW
    Passenger door courtesy switch signal / ON or OFF
    ON: Passenger side door is open
    OFF: Passenger side door is closed
    -
    Rear Door Courtesy SW
    Rear door courtesy switch signal / ON or OFF
    ON: Either rear right or left door is open
    OFF: Both rear right and left doors are closed
    -
    Back Door Open SW
    Back door open switch
    ON: Back door is open
    OFF: Back door is closed
    -
    Rear Lock Position SW
    Rear door lock position switch signal / ON or OFF
    ON: Rear door lock is in unlock position
    OFF: Rear door lock is in lock position
    -
    Passenger Lock Pos SW
    Passenger door lock position switch signal / ON or OFF
    ON: Passenger side door lock is in unlock position
    OFF: Passenger side door lock is in lock position
    -
    D Door Lock Pos SW
    Driver door lock position switch signal / ON or OFF
    ON: Driver side door is in unlock position
    OFF: Driver side door is in lock position
    -
    Hood Courtesy SW
    Engine hood courtesy switch signal / ON or OFF
    ON: Engine hood is open
    OFF: Engine hood is closed
    -
    IG SW
    Power switch signal / ON or OFF
    ON: Power switch is pushed
    OFF: Power switch is not pushed
    -


PERFORM ACTIVE TEST

HINT:
Performing the Techstream's Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.

  1. Connect Techstream (with CAN VIM) to the DLC3.

  2. Turn the power switch ON (IG).

  3. Perform the Active Test according to the display on the tester.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Security Indicator
    Turn security indicator light ON / OFF
    -
    Security Horn
    Sound security horn ON / OFF
    -
    Vehicle Horn
    Sound vehicle horn ON / OFF
    -