Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > CUSTOMIZE PARAMETERS


HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that customization of the function is possible.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.


CUSTOMIZE
  1. Connect Techstream to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Turn the tester on.

  4. Enter the following menus:
    Select: Customize Setting

  5. Select the setting by referring to the table below.


Security 
Display (Item)
Default
Contents
Setting
Passive Mode
OFF
PASSIVE MODE is a function that switches theft deterrent system from arming preparation state to armed state 30 seconds after key is removed from key slot and all doors is closed, even if doors are not locked by wireless or door key lock operation.
In PASSIVE MODE, theft deterrent system will judge that a theft is taking place and switch to alarm sounding state if one of the following operations are not performed within 14 seconds (see ENTRY DELAY below) after door is opened:
  1. Unlock any door by key or wireless operation
  2. Reconnect battery
  3. Insert key into key slot and turn power switch ON (IG)
ON / OFF
Warning by Horn
ON
Function that allows vehicle horn and theft deterrent horn to be able to be used and a warning device
ON / OFF
Entry Delay Time
14 s
Function that changes entry delay time (time before warning states)
0 s/14 s/ 30 s
Warning by Glass Sen
ON
Function that turns glass broken sensor ON/OFF
ON / OFF