Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 FLOOR BOARD


    A088353E01
  1. Unlock the 2 washer tank cover knobs, and then remove the rear floor board.



2. REMOVE REAR DECK FLOOR BOX


    A088354E01
  1. Remove the rear deck floor box from the vehicle.



3. REMOVE REAR NO. 3 FLOOR BOARD


    A088355E02
  1. Detach the 4 claws, and then remove the floor board.



4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



5. REMOVE ACCELERATOR PEDAL ROD


    A087530E01
  1. Disconnect the accelerator pedal position sensor connector.

  1. Remove the 2 bolts, then remove the accelerator pedal rod.