Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ACCELERATOR PEDAL ROD

NOTICE:
  1. Do not remove the accelerator pedal position sensor from the accelerator pedal.
  2. Perform the inspection on the hybrid vehicle control ECU side of the connector.

  1. Turn the power switch ON (IG).



  1. Using a voltmeter, measure the voltage between the terminals.

    Standard voltage:
    Tester Connection
    Measuring Condition
    Specified Condition
    B-25 (VCP) - B-27 (EP1)
    Normal
    4.5 to 5.5 V
    B-26 (VPA1) - B-27 (EP1)
    Do not depress the accelerator pedal
    0.5 to 1.1 V
    B-26 (VPA1) - B-27 (EP1)
    Gradually depress the accelerator pedal
    The voltage increases slowly
    B-26 (VPA1) - B-27 (EP1)
    Fully depress the accelerator pedal
    2.6 to 4.5 V
    B-33 (VCP2) - B-35 (EP2)
    Normal
    4.5 to 5.5 V
    B-34 (VPA2) - B-35 (EP2)
    Do not depress the accelerator pedal
    1.2 to 2.0 V
    B-34 (VPA2) - B-35 (EP2)
    Gradually depress the accelerator pedal
    The voltage increases slowly
    B-34 (VPA2) - B-35 (EP2)
    Fully depress the accelerator pedal
    3.4 to 5.3 V



    A130645E02

    If the standards are not met, replace the accelerator pedal rod.