BATTERY ECU > INSTALLATION |
| 1. INSTALL BATTERY ECU |
Install the battery ECU with the 2 screws.

Install the aluminum shield wire of the main battery cable together with the battery ECU with a new nut.
Connect the clamp and No. 2 frame wire connector.
Connect the thermistor connector.
![]() |
Connect the system main relay connector.
| 2. INSTALL JUNCTION TERMINAL |
![]() |
| 3. INSTALL NO. 6 BATTERY CARRIER PANEL |
![]() |
Install the battery carrier panel with the bolt and 2 nuts.
| 4. INSTALL BATTERY CARRIER BRACKET |
![]() |
Install the battery carrier bracket with the 7 bolts.
| 5. INSTALL DECK TRIM SIDE PANEL LH |
Connect the lighting connector.
![]() |
Install the deck trim side panel with the 8 clips and 2 bolts, and then install the part of the weather strip.
Install the luggage hold belt striker with the bolt.
| 6. INSTALL DECK FLOOR BOX LH |
![]() |
Install the deck floor box with the clip.
| 7. INSTALL REAR NO. 4 FLOOR BOARD |
![]() |
| 8. INSTALL REAR SIDE SEAT BACK FRAME LH |
![]() |
Install the seat back frame with the bolt.
| 9. INSTALL REAR NO. 1 FLOOR BOARD |
![]() |
Install the floor board.
Install the 2 luggage strikers with the 2 bolts.
| 10. INSTALL REAR SEAT CUSHION ASSEMBLY |
![]() |
| 11. INSTALL TONNEAU COVER |
![]() |
| 12. INSTALL REAR DECK TRIM COVER |
![]() |
| 13. INSTALL SERVICE PLUG GRIP |
Joint the service plug grip with the HV battery.
While pushing the service plug grip to the right, rotate the lever to the right.
Slide the lever down to lock the service plug grip in place.

| 14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
![]() |
Connect the battery negative cable, and then tighten the nut.
| 15. INSTALL REAR NO. 3 FLOOR BOARD |
![]() |
Install the floor board, and then attach the 4 claws.
| 16. INSTALL REAR DECK FLOOR BOX |
![]() |
Install the rear deck floor box to the vehicle.
| 17. INSTALL REAR NO. 2 FLOOR BOARD |
![]() |
Install the floor board, and then lock the 2 cover knobs.
| 18. PERFORM INITIALIZATION |
Perform initialization (Click here).