Home › HYBRID SYSTEM › P112 HYBRID BATTERY CONTROL › BATTERY BLOWER

BATTERY BLOWER > INSTALLATION

for Preparation Click here



1. INSTALL BATTERY BLOWER


    A083526E01
  1. Connect the connector to the battery blower.

  1. Install the clamp on the battery blower.

  1. Install the battery blower with the 3 nuts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



2. INSTALL VENTILATOR DUCT INNER


    A083529E01
  1. Install the ventilator duct inner with the 3 clips.



3. INSTALL NO. 2 QUARTER VENT DUCT INNER


    A083530E02
  1. Insert the quarter vent duct inner until it touches the backside of the HV battery.

  1. Slide the fitting surface of the quarter vent duct inner downward, then attach it to the battery blower assembly.

    NOTICE:
    Ensure that the duct is installed securely.

  1. Install the 2 clips on the vent duct.

  1. Install the battery blower relay.



4. INSTALL DECK TRIM SIDE PANEL RH


    A083538E05
  1. Install the deck trim side panel with the 7 clips and 2 bolts, and then install the part of the weather strip.

  1. Install the luggage hold belt striker with the bolt.



5. INSTALL REAR SIDE SEAT BACK FRAME RH


    A083539E03
  1. Install the seat back frame with the bolt.



6. INSTALL REAR NO. 1 FLOOR BOARD


A083543E03
  1. Install the floor board.

  1. Install the 2 luggage strikers with the 2 bolts.



7. INSTALL REAR SEAT CUSHION ASSEMBLY


A083593E03


8. INSTALL TONNEAU COVER


A083594E01


9. INSTALL REAR DECK TRIM COVER


A083536E03


10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
  1. When the warning light is illuminated or the battery has been disconnected and reconnected, turning the power switch may not start the system on the first try. If so, turn the power switch again.
  2. With the power switch's power mode changed to ON (IG), disconnect the battery. If the key is not in the key slot during reconnection, DTC B2799 may be output.



    A088356E01
  1. Connect the battery negative cable, and then tighten the nut.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



11. INSTALL REAR NO. 3 FLOOR BOARD


    A088355E02
  1. Install the floor board, and then attach the 4 claws.



12. INSTALL REAR DECK FLOOR BOX


    A088354E01
  1. Install the rear deck floor box to the vehicle.



13. INSTALL REAR NO. 2 FLOOR BOARD


    A088353E01
  1. Install the floor board, and then lock the 2 cover knobs.



14. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.