Home › HYBRID SYSTEM › P112 HYBRID BATTERY CONTROL › BATTERY BLOWER

BATTERY BLOWER > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 FLOOR BOARD


    A088353E01
  1. Unlock the 2 washer tank cover knobs, and then remove the rear floor board.



2. REMOVE REAR DECK FLOOR BOX


    A088354E01
  1. Remove the rear deck floor box from the vehicle.



3. REMOVE REAR NO. 3 FLOOR BOARD


    A088355E02
  1. Detach the 4 claws, and then remove the floor board.



4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



5. REMOVE REAR DECK TRIM COVER


    A083536E03
  1. Detach the 4 clips shown in the illustration, then remove the deck trim cover.



6. REMOVE TONNEAU COVER


    A083594E01
  1. Remove the tonneau cover from the vehicle.



7. REMOVE REAR SEAT CUSHION ASSEMBLY


    A083593E03
  1. Undo the 2 joints shown in the illustration, then remove the rear seat cushion.



8. REMOVE REAR NO. 1 FLOOR BOARD


    A083543E03
  1. Remove the 2 bolts and luggage hold belt strikers.

  1. Remove the 5 clips shown in the illustration and the rear floor board.



9. REMOVE REAR SIDE SEAT BACK FRAME RH


    A083539E03
  1. Remove the bolt from the rear side seat back frame RH.

  1. Undo the 4 joints, then remove the rear side seat back frame RH.



10. REMOVE DECK TRIM SIDE PANEL RH
  1. Remove the bolt and luggage hold belt striker.



    A083538E05
  1. Remove the 2 bolts from the deck trim side panel RH.

  1. Remove the clip from the deck trim side panel RH.

  1. Undo the 7 clips, then pull out a part of the weather strip and remove the deck trim side panel RH.



11. REMOVE NO. 2 QUARTER VENT DUCT INNER


    A083530E02
  1. Disconnect the clamp and No. 1 battery blower relay.

  1. Remove the 2 clips.

  1. Slide the vent duct to the battery side, then remove it.



12. REMOVE VENTILATOR DUCT INNER


    A083529E01
  1. Remove the 3 clips and ventilator duct inner.



13. REMOVE BATTERY BLOWER


    A083526E01
  1. Remove the 3 nuts, then disconnect the battery blower assembly from the vehicle.

  1. Remove the connector, clamp and battery blower.