DTC P0500 Vehicle Speed Sensor "A" |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0500 | This trouble code is output when a signal from vehicle speed sensor is cut for 1.4 seconds or more while cruise control is in operation |
|

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check if the function of the speedometer in the combination meter is normal.
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM (VEHICLE SPEED SIGNAL) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Cruise Control / Data List.
Check that the speed displayed on the Techstream's screen is the same as the one indicated on the combination meter.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| CCS Vehicle Speed | Cruise control vehicle speed/min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) | Actual vehicle speed | - |
|
| ||||
| NG | |
| 3.INSPECT HYBRID VEHICLE CONTROL ECU (SPD VOLTAGE) |
![]() |
Turn the power switch ON (IG).
Move the shift lever to neutral.
Jack up the vehicle.
Measure the voltage of the connector.
| Tester Connection | Specified Condition |
| SPDI (H14-19) - Body ground | Waveform appears |
|
| ||||
| NG | |
| 4.CHECK WIRE HARNESS (ECU - METER) |
![]() |
Disconnect the H14 ECU connector.
Disconnect the C10 meter connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| SPDI (H14-19) - C10-13 | Below 1 Ω |
|
| ||||
| OK | ||
| ||