Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

DTC    P0571    Brake Switch "A" Circuit

for Preparation Click here


DESCRIPTION

When the brake pedal is depressed, the stop light switch sends a signal to the hybrid vehicle control ECU.
Receiving the signal, the hybrid vehicle control ECU cancels the cruise control. Even if there is a malfunction in the stop light signal circuit while the cruise control is in operation, normal driving is maintained due to fail-safe function.
Cruise control is canceled when positive battery voltage is applied to terminal STP.
When the brake pedal is depressed, positive voltage is applied to terminal STP of the hybrid vehicle control ECU through the STOP fuse and the stop light switch, and the hybrid vehicle control ECU cancels the cruise control.
When the brake pedal is released, positive voltage is applied to terminal ST1- of the hybrid vehicle control ECU through the IGN fuse and the stop light switch, and the hybrid vehicle control ECU operates the cruise control.

HINT:
Inspect the fuses and relays before confirming the suspected areas which are shown in the table below.


DTC No.
DTC Detection Condition
Trouble Area
P0571
Trouble code is output when voltages of terminals ST1- and STP of the hybrid vehicle control ECU are both below 1 V for 0.5 seconds or more
  1. Stop light switch
  2. Stop light switch circuit
  3. Hybrid vehicle control ECU

WIRING DIAGRAM


E124731E02


INSPECTION PROCEDURE

1.INSPECT STOP LIGHT SWITCH OPERATION
  1. Check that the stop light turns on when the brake pedal is depressed, and goes off when the brake pedal is released.

    OK:
    The stop light turns on/turns off normally.

    HINT:
    The stop light uses the circuit on the terminal STP side of the hybrid vehicle control ECU.



NG
GO TO STOP LIGHT SWITCH CIRCUIT
OK


2.INSPECT STOP LIGHT SWITCH ASSEMBLY
I004062E05
  1. Remove the stop light switch.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 - 4
    Not pushed
    Below 1 Ω
    Pushed
    10 kΩ or higher



NG
REPLACE STOP LIGHT SWITCH ASSEMBLY
OK


3.CHECK WIRE HARNESS (SWITCH - BATTERY)
E110511E06
  1. Disconnect the S16 switch connector.

  1. Measure the voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    S16-3 - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HYBRID VEHICLE CONTROL ECU
I039294E01
  1. Reconnect the S16 switch connector.

  1. Disconnect the H15 ECU connector.

  1. Turn the power switch ON (IG).

  1. Measure the voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Switch Connection
    Specified Condition
    STP (H15-3) - Body ground
    Brake pedal is depressed
    10 to 14 V
    Brake pedal is released
    Below 1 V
    ST1- (H15-2) - Body ground
    Brake pedal is released
    10 to 14 V
    Brake pedal is depressed
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE HYBRID VEHICLE CONTROL ECU