Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > ROAD TEST

for Preparation Click here



PROBLEM SYMPTOM CONFIRMATION


    I102366
  1. Inspect the SET function.

    1. Push the ON-OFF button "on".

    2. Drive at the required speed (40 km/h (25 mph) or higher).

    3. Push the cruise control main switch to -/SET.

    4. Check that the vehicle cruises at the set speed after releasing the switch.



  2. I102367
  3. Inspect the "+ (ACCEL)" function.

    1. Push the ON-OFF button "on".

    2. Drive at the required speed (40 km/h (25 mph) or higher).

    3. Push the cruise control main switch to -/SET.

    4. Check that vehicle speed increases while the cruise control main switch is pushed to +/RES, and that the vehicle cruises at the newly set speed when the switch is released.

    5. Momentarily push the cruise control main switch to +/RES and then immediately release it. Check that vehicle speed increases by approximately 1.6 km/h (1.0 mph) (tap-up function).



  4. I102366
  5. Inspect the "- (COAST)" function.

    1. Push the ON-OFF button "on".

    2. Drive at the required speed (40 km/h (25 mph) or higher).

    3. Push the cruise control main switch to -/SET.

    4. Check that vehicle speed decreases while the cruise control main switch is pushed to -/SET, and that the vehicle cruises at the newly set speed when the switch is released.

    5. Momentarily push the cruise control main switch to -/SET and then immediately release it. Check that vehicle speed decreases by approximately 1.6 km/h (1.0 mph) (tap-down function).



  6. I102368
  7. Inspect the CANCEL function.

    1. Push the ON-OFF button "on".

    2. Drive at the required speed (40 km/h (25 mph) or higher).

    3. Push the cruise control main switch to -/SET.

    4. When doing one or more of the following, check that the cruise control system is canceled and that the normal driving mode is reset:

      1. Depressing the brake pedal
      2. Shifting into any position except D
      3. Pushing the ON-OFF button "off"
      4. Pulling the cruise control main switch to CANCEL



  8. I102367
  9. Inspect the RES (RESUME) function.

    1. Push the ON-OFF button "on".

    2. Drive at the required speed (40 km/h (25 mph) or higher).

    3. Push the cruise control main switch to -/SET.

    4. When doing one or more of the following, check that the cruise control system is canceled and that the normal driving mode is reset:

      1. Depressing the brake pedal
      2. Shifting into any position except D
      3. Pulling the cruise control main switch to CANCEL

    5. After pushing the cruise control main switch to +/RES at a driving speed of more than 40 km/h (25 mph), check that the vehicle restores the speed which was maintained before cancellation.