Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Powertrain / Cruise Control / Data List.

  5. Read the Data List according to the display on the Techstream.

    Hybrid Vehicle Control ECU (Cruise Control): 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    CCS Vehicle Spd
    Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)
    Actual vehicle speed
    -
    CCS Mem Vehicle Spd
    Cruise control memorized speed / min.: 0 km/h (0 mph), max.: 200 km/h (125 mph)
    Actual stored vehicle speed
    -
    Stop Light SW M-CPU
    Stop light switch signal (Main CPU) / ON or OFF
    ON: Brake pedal depressed
    OFF: Brake pedal released
    -
    Throttle Opening Angle
    Throttle opening angle / min.: 0°, max.: 125°
    Actual demanded throttle angle
    -
    Cruise Control
    Cruise control system active condition / ON or OFF
    ON: Cruise control system activated
    OFF: Cruise control system deactivated
    -
    Main SW M-CPU
    Main switch signal (Main CPU) / ON or OFF
    ON: Cruise control main switch on
    OFF: Cruise control main switch off
    "3"
    CCS Ready M-CPU
    Cruise control system standby condition (Main CPU) / ON or OFF
    ON ←→ OFF: Switching each time ON-OFF button is pushed
    "1"
    CCS Indicator M-CPU
    Cruise indicator signal (Main CPU) / ON or OFF
    ON: "CRUISE" on
    OFF: "CRUISE" off
    "2"
    Cancel Switch
    CANCEL switch signal / ON or OFF
    ON: CANCEL switch on
    OFF: CANCEL switch off
    -
    SET/COAST Switch
    SET / COAST switch signal / ON or OFF
    ON: - (COAST) / SET switch on
    OFF: - (COAST) / SET switch off
    -
    RES/ACC Switch
    RES / ACC switch signal / ON or OFF
    ON: + (ACCEL) / RES (RESUME) switch on
    OFF: + (ACCEL) / RES (RESUME) switch off
    -
    Cruise Operation Status
    Cruise control condition / ON or OFF
    ON: Cruise control operating
    OFF: Cruise control not operating
    -
    Vehicle Spd Change
    Vehicle speed sudden change / ON or OFF
    ON: Sudden change in vehicle speed
    OFF: No change in vehicle speed
    -
    # Codes
    Number of DTC recorded / 0 to 255
    min.: 0
    max.: 3
    -

    HINT:
    1. "3" is OK but "1" is NG → Hybrid vehicle control ECU failure
    2. "1" is OK but "2" is NG → DTC output or hybrid vehicle control ECU failure
    3. "3" is OK but the CRUISE main indicator light does not turn on → CRUISE main indicator light, wire harness, or hybrid vehicle control ECU failure