Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > FAIL-SAFE CHART

for Preparation Click here



FAIL-SAFE CHART
If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the hybrid vehicle control ECU and cancels the cruise control operation.

Cruise control system 
Vehicle Condition
Auto Cancel Condition
Re-operation Condition
CRUISE main indicator light blinks
When either condition below is met:
  1. There is an open or short in stop light switch circuit
  2. Vehicle speed signal changes suddenly
Push cruise control main switch ON-OFF button "on" again
CRUISE main indicator light blinks
There is a problem with input circuit of stop light switch circuit
When either condition below is met:
  1. Indicator light blinks until cruise control main switch ON-OFF button is pushed on again
  2. Constant speed control is prohibited until the power switch is turned OFF
CRUISE main indicator light turns off
When either condition below is met:
  1. Vehicle speed is below the low speed limit (approx. 40 km/h (approx. 25 mph)) while driving with cruise control on
  2. Vehicle speed is lower than stored speed by approx. 16 km/h (approx. 9.9 mph) or more while driving with cruise control on
Push cruise control main switch to -/RES