Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit

for Preparation Click here


DESCRIPTION

The hybrid vehicle control ECU outputs the cruise control operation status to the CRUISE main indicator light on the combination meter.
The CRUISE main indicator light circuit uses CAN and BEAN for communication. If there are any malfunctions in this circuit, check for DTCs in the CAN communication system and the multiplex communication system.

INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (CRUISE MAIN INDICATOR LIGHT)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the Techstream on.

  1. Enter the following menus: Powertrain / Cruise Control / Data List.

  1. Check the Data List for proper functioning of the cruise control main switch.

    Hybrid Vehicle Control ECU (Cruise Control): 
    Tester Display
    Measurement Item/Display
    Normal Condition
    Diagnostic Note
    CCS Indicator M-CPU
    Cruise indicator signal (Main CPU) / ON or OFF
    ON: CRUISE main indicator is ON
    OFF: CRUISE main indicator is OFF
    -

    OK:
    Cruise control indicator light illuminates.


    Result:

    Result
    Proceed to
    OK
    A
    NG (ON / OFF operates only on the Techstream)
    (Click here)
    B
    NG (ON / OFF does not operate only on the Techstream)
    C



B
GO TO METER / GAUGE SYSTEM

C
REPLACE HYBRID VEHICLE CONTROL ECU
A

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE