Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1262    A/C ECU Communication Stop

for Preparation Click here


DESCRIPTION

This DTC is detected when communication between the A/C ECU and gateway ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1262
A/C ECU communication stops
  1. A/C ECU
  2. Wire harness

WIRING DIAGRAM


B129732E01


INSPECTION PROCEDURE

1.CHECK OPERATION
  1. Check that the A/C switch can operate the air conditioner normally.

    OK:
    A/C switch can operate the air conditioner normally.



OK
Go to step 3
NG


2.CHECK WIRE HARNESS (A/C ECU - BODY GROUND)


    B126184E02
  1. Disconnect the A8 ECU connector.

  1. Measure the resistance and voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    A8-1 (GND) - Body ground
    Below 1 Ω
    Standard voltage:
    Tester Connection
    Specified Condition
    A8-6 (+B) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK RESISTANCE OF COMMUNICATION LINE

B126185E01

  1. Disconnect the A8 and G1 ECU connectors.

  1. Disconnect the 1G junction block connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A8-3 (MPX+) - G1-12 (MPD2)
    Below 1 Ω
    A8-11 (MPX2+) - 1G-9 (MPX1)
    Below 1 Ω

    Result:
    Result
    Proceed to
    Both are OK
    A
    One is OK
    B
    Both are NG
    C



B
REPLACE A/C ECU AND REPAIR OR REPLACE HARNESS AND CONNECTOR

C
REPAIR OR REPLACE HARNESS AND CONNECTOR
A

REPLACE A/C ECU