Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1271    Combination Meter ECU Communication Stop

for Preparation Click here


DESCRIPTION

This DTC is detected when communication between the combination meter and gateway ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1271
Combination meter ECU communication stops
  1. Combination meter
  2. Wire harness

WIRING DIAGRAM


B126186E04


INSPECTION PROCEDURE

1.CHECK OPERATION
  1. Check that the indicator (READY) on the combination meter illuminates when the hybrid vehicle control system is operating (power switch ON (READY)).

    OK:
    Indicator can operate properly.



OK
Go to step 3
NG


2.CHECK WIRE HARNESS (COMBINATION METER - BODY GROUND)


    B126419E03
  1. Disconnect the C10 meter connector.

  1. Measure the resistance and voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    C10-14 - Body ground
    Below 1 Ω
    Standard voltage:
    Tester Connection
    Specified Condition
    C10-21 - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK RESISTANCE OF COMMUNICATION LINE

B131881E01

  1. Disconnect the C10 meter connector.

  1. Disconnect the P6 and T11 ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    C10-24 (MPX+) - T11-12 (MPX2)
    Below 1 Ω
    C10-25 (MPX-) - P6-7 (MPX1)
    Below 1 Ω

    Result:
    Result
    Proceed to
    Both are OK
    A
    One is OK
    B
    Both are NG
    C



B
REPLACE COMBINATION METER AND REPAIR OR REPLACE HARNESS AND CONNECTOR

C
REPAIR OR REPLACE HARNESS AND CONNECTOR
A

REPLACE COMBINATION METER