Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1248    AVC-LAN Communication Impossible

for Preparation Click here


DESCRIPTION

This DTC is detected when communication is impossible between the multi-display and gateway ECU.

DTC No.
DTC Detection Condition
Trouble Area
B1248
AVC-LAN communication is impossible
  1. Multi-display
  2. Wire harness

WIRING DIAGRAM


B126178E02


INSPECTION PROCEDURE

1.CHECK OPERATION
  1. Check that the radio and player switch can operate normally.

    OK:
    Radio and player switch can operate normally.



NG
GO TO AUDIO SYSTEM
OK


2.CHECK RESISTANCE OF COMMUNICATION LINE


    B162015E01
  1. Disconnect the G1 ECU connector.

  1. Disconnect the M13 display connector.

  1. Measure the resistance between the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    M13-4 (TX1+) - G1-6 (GTX+)
    Below 1 Ω
    M13-5 (TX1-) - G1-21 (GTX-)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE MULTI-DISPLAY