Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1294    Immobiliser ECU Communication Stop

for Preparation Click here


DESCRIPTION

This DTC is detected when communication between the transponder key ECU and gateway ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1294
Transponder key ECU communication stops
  1. Transponder key ECU
  2. Wire harness

WIRING DIAGRAM


B129733E01


INSPECTION PROCEDURE

1.INSPECT FUSE (IGN)
  1. Remove the IGN fuse from the driver side junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (TRANSPONDER KEY ECU - BODY GROUND)


    B127153E02
  1. Disconnect the T5 ECU connector.

  1. Measure the resistance and voltage of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T5-22 (GND) - Body ground
    Below 1 Ω
    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    T5-4 (IG) - Body ground
    Power switch ON (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK RESISTANCE OF COMMUNICATION LINE

B126190E01

  1. Disconnect the T4, T5 and B5 ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T5-17 (MPX1) - B5-15 (MPX2)
    Below 1 Ω
    T5-16 (MPX2) - T4-18 (MPX2)
    Below 1 Ω

    Result:
    Result
    Proceed to
    Both are OK
    A
    One is OK
    B
    Both are NG
    C



B
REPLACE TRANSPONDER KEY ECU AND REPAIR OR REPLACE HARNESS AND CONNECTOR

C
REPAIR OR REPLACE HARNESS AND CONNECTOR
A

REPLACE TRANSPONDER KEY ECU