Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1200    MPX Body ECU Stop

for Preparation Click here


DESCRIPTION

This DTC is detected when communication between the main body ECU and gateway ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1200
Body ECU communication stops
  1. Driver side junction block
  2. Wire harness

WIRING DIAGRAM


B129722E01


INSPECTION PROCEDURE

1.INSPECT FUSE (DOME)
  1. Remove the DOME fuse from the engine room junction block and relay block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (DRIVER SIDE JUNCTION BLOCK - BATTERY AND BODY GROUND)


    B126171E01
  1. Disconnect the 1A and 1E junction block connectors.

  1. Measure the resistance and voltage of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    1E-17 (GND) - Body ground
    Below 1 Ω
    Standard voltage:
    Tester Connection
    Specified Condition
    1A-30 (ECUB) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK COMMUNICATION LINE

B129723E01

  1. Disconnect the 1G junction block connector.

  1. Disconnect the T5, A8 and B5 ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T5-17 (MPX1) - B5-15 (MPX2)
    Below 1 Ω
    A8-11 (MPX2+) - 1G-9 (MPX1)
    Below 1 Ω

    Result:
    Result
    Proceed to
    Both are OK
    A
    One is OK
    B
    Both are NG
    C



B
REPLACE DRIVER SIDE JUNCTION BLOCK

C
REPLACE DRIVER SIDE JUNCTION BLOCK AND REPAIR OR REPLACE HARNESS AND CONNECTOR
A

REPLACE DRIVER SIDE JUNCTION BLOCK