Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1207    Smart ECU Stop

for Preparation Click here


DESCRIPTION

This DTC is detected when communication between the certification ECU and gateway ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1207
Certification ECU communication
  1. Certification ECU
  2. Wire harness

WIRING DIAGRAM


B126173E02


INSPECTION PROCEDURE

1.CHECK OPERATION
  1. With the key in your possession, push the lock button on the door outside handle (entry lock operation). Check that the key warning light illuminates or starts blinking.
    With the key in your possession, touch the inside of the door outside handle (entry unlock operation). Check that the key warning light illuminates or starts blinking.

    OK:
    Key warning light illuminates or starts blinking.



OK
Go to step 3
NG


2.CHECK WIRE HARNESS (CERTIFICATION ECU - BODY GROUND)


    B127139E01
  1. Disconnect the S11 ECU connector.

  1. Measure the resistance and voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    S11-17 (E) - Body ground
    Below 1 Ω
    Standard voltage:
    Tester Connection
    Specified Condition
    S11-1 (+B1) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK RESISTANCE OF COMMUNICATION LINE

B130304E02

  1. Disconnect the S11, T4 and T11 ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    S11-31 (MPX1) - T4-19 (MPX1)
    Below 1 Ω
    S11-32 (MPX2) - T11-6 (MPX1)
    Below 1 Ω

    Result:
    Result
    Proceed to
    Both are OK
    A
    One is OK
    B
    Both are NG
    C



B
REPLACE CERTIFICATION ECU AND REPAIR OR REPLACE HARNESS AND CONNECTOR

C
REPAIR OR REPLACE HARNESS AND CONNECTOR
A

REPLACE CERTIFICATION ECU