Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1210    Power ECU Stop

for Preparation Click here


DESCRIPTION

This DTC is detected when communication between the power source control ECU and gateway ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1210
Power source control communication stops
  1. Power source control ECU
  2. Wire harness

WIRING DIAGRAM


B126176E03


INSPECTION PROCEDURE

1.CHECK OPERATION
  1. Without depressing the brake pedal, push the power switch repeatedly. Check that the power mode changes between OFF, ON (ACC) and ON (IG) alternately.

    OK:
    Key warning light illuminates or starts blinking according to power modes.



OK
Go to step 3
NG


2.CHECK WIRE HARNESS (POWER SOURCE CONTROL ECU - BODY GROUND)


    B127139E03
  1. Disconnect the P6 ECU connector.

  1. Measure the resistance and voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    P6-6 (GND2) - Body ground
    Below 1 Ω
    Standard voltage:
    Tester Connection
    Specified Condition
    P6-33 (AM1) - Body ground
    10 to 14 V
    P6-12 (AM2) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK RESISTANCE OF COMMUNICATION LINE

B126177E01

  1. Disconnect the P6 and G1 ECU connectors.

  1. Disconnect the C10 meter connector.

  1. Measure the resistance between the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    P6-7 (MPX1) - C10-25 (MPX-)
    Below 1 Ω
    P6-24 (MPX2) - G1-3 (MPD1)
    Below 1 Ω

    Result:
    Result
    Proceed to
    Both are OK
    A
    One is OK
    B
    Both are NG
    C



B
REPLACE POWER SOURCE CONTROL ECU AND REPAIR OR REPLACE HARNESS AND CONNECTOR

C
REPAIR OR REPLACE HARNESS AND CONNECTOR
A

REPLACE POWER SOURCE CONTROL ECU