Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1260    "P" Position Control ECU Stop

for Preparation Click here


DESCRIPTION

This DTC is detected when communication between the transmission control ECU and gateway ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1260
Transmission control ECU communication stops
  1. Transponder control ECU
  2. Wire harness

WIRING DIAGRAM


B126180E03


INSPECTION PROCEDURE

1.INSPECT FUSE (HEV)
  1. Remove the HEV fuse from the engine room junction block.

  1. Measure the resistance.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (TRANSMISSION CONTROL ECU - BODY GROUND)


    B126181E02
  1. Disconnect the T4 ECU connector.

  1. Measure the resistance and voltage between the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    T4-15 (E1) - Body ground
    Below 1 Ω
    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    T4-1 (+B) - Body ground
    Power switch ON (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK RESISTANCE OF COMMUNICATION LINE

B131880E01

  1. Disconnect the T4, T5 and S11*1 or T11*2 ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T4-18 (MPX2) - T5-16 (MPX2)
    Below 1 Ω
    T4-19 (MPX1) - S11-31 (MPX1)*1
    Below 1 Ω
    T4-19 (MPX1) - T11-6 (MPX1)*2
    Below 1 Ω

    HINT:
    *1: w/ Smart key system (for door lock)
    *2: w/o Smart key system (for door lock)

    Result:
    Result
    Proceed to
    Both are OK
    A
    One is OK
    B
    Both are NG
    C



B
REPLACE TRANSMISSION CONTROL ECU AND REPAIR OR REPLACE HARNESS AND CONNECTOR

C
REPAIR OR REPLACE HARNESS AND CONNECTOR
A

REPLACE TRANSMISSION CONTROL ECU