Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > DIAGNOSIS SYSTEM



DESCRIPTION
  1. Theft deterrent system data and the Diagnostic Trouble Codes (DTCs) can be read through the vehicle's Data Link Connector 3 (DLC3). When the system seems to be malfunctioning, use Techstream to check for malfunctions and perform repairs.


CHECK DLC3


    H100769E16
  1. The vehicle uses the ISO 15765-4 communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.

    Symbols (Terminal No.)
    Terminal Description
    Condition
    Specified Condition
    SIL (7) - SG (5)
    Bus "+" line
    During transmission
    Pulse generation
    CG (4) - Body ground
    Chassis ground
    Always
    Below 1 Ω
    SG (5) - Body ground
    Signal ground
    BAT (16) - Body ground
    Battery positive
    11 to 14 V
    CANH (6) - CANL (14)
    HIGH-level CAN bus line
    Power switch OFF
    54 to 69 Ω
    CANH (6) - Battery positive
    1 kΩ or higher
    CANH (6) - CG (4)
    1 kΩ or higher
    CANL (14) - Battery positive
    LOW-level CAN bus line
    1 MΩ or higher
    CANL (14) - CG (4)
    1 MΩ or higher
    If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.

    HINT:
    Connect the cable of Techstream (with CAN VIM) to the DLC3, turn the power switch ON (IG) and attempt to use the tester. If the display indicates the message UNABLE TO CONNECT TO VEHICLE, there is a problem either with the vehicle or with the tester.
    1. If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
    2. If communication is still not possible when the tester is connected to another vehicle, the problem is probably in the tester itself. Consult the Service Department listed in the tester's instruction manual.