Home › ENGINE › 1NZ-FXE ENGINE CONTROL SYSTEM › CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY


A087549E02
  1. Apply a light coat of engine oil to a new O-ring, then install it to the camshaft timing oil control valve.

  1. Install the camshaft timing oil control valve with the bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    NOTICE:
    Be careful that the O-ring is not cracked or jammed when installing it.

  1. Connect the camshaft timing oil control valve connector.



2. INSTALL AIR CLEANER ASSEMBLY


    A087416E02
  1. Install the air cleaner with the 2 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Tighten the hose clamp bolt.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

  1. Connect the No. 1 air cleaner inlet, and tighten the hose clamp bolt.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

  1. Connect the MAF meter connector.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. INSPECT FOR OIL LEAK


5. INSTALL RADIATOR SUPPORT OPENING COVER


    A087414E01
  1. Install the cover with the 6 clips.



6. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.