Home › ENGINE › 1NZ-FXE ENGINE CONTROL SYSTEM › CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE RADIATOR SUPPORT OPENING COVER


A087414E01
  1. Remove the 6 clips and radiator support opening cover.



3. REMOVE AIR CLEANER ASSEMBLY


A087415E01
  1. Disconnect the MAF meter connector.

  1. Disconnect the wire harness from the wire harness clamp.

  1. Loosen the hose clamp bolt, and then disconnect the No. 1 air cleaner inlet.



    A087416E02
  1. Remove the 2 bolts.

  1. Loosen the hose clamp bolt, and then remove the air cleaner.



4. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY


A087587E01
  1. Disconnect the camshaft timing oil control valve connector.

  1. Remove the bolt and camshaft timing oil control valve.