Home › ENGINE › 1NZ-FXE ENGINE CONTROL SYSTEM › KNOCK SENSOR

KNOCK SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE RADIATOR SUPPORT OPENING COVER


A087414E01
  1. Remove the 6 clips and radiator support opening cover.



3. REMOVE ENGINE UNDER COVER LH


4. DRAIN ENGINE COOLANT
  1. Disconnect the coolant heat storage water pump connector.

  1. Connect a vinyl hose to the drain cock of the radiator.

  1. Connect a vinyl hose to the drain cock of the engine.

  1. Connect a vinyl hose to the drain cock of the coolant heat storage tank.

    CAUTION:
    If the tank has any malfunctions, the tank surface becomes hot. To prevent injuries from burns, do not touch the tank.

  1. Loosen the drain cock plugs of the radiator, engine and coolant heat storage tank, then drain the coolant.

    CAUTION:
    Even if the engine is cold, the coolant in the coolant heat storage tank is still hot. Be careful of the hot coolant when draining it.

    HINT:
    Record the amount of the drained coolant. It will be referred to when refilling the tank with coolant.



  1. Remove the radiator cap.


    A124655E01

  1. Drain the coolant in the radiator reservoir.



5. REMOVE AIR CLEANER ASSEMBLY


A087415E01
  1. Disconnect the MAF meter connector.

  1. Disconnect the wire harness from the wire harness clamp.

  1. Loosen the hose clamp bolt, and then disconnect the No. 1 air cleaner inlet.



    A087416E02
  1. Remove the 2 bolts.

  1. Loosen the hose clamp bolt, and then remove the air cleaner.



6. REMOVE OIL DIPSTICK GUIDE


A087582E01
  1. Remove the dipstick.

  1. Disconnect the wire harness clamp.

  1. Remove the bolt and dipstick guide.



7. REMOVE INTAKE MANIFOLD SUB-ASSEMBLY


A087573E01
  1. Disconnect the ventilation hose from the throttle with motor body.

  1. Disconnect the No. 2 ventilation hose.

  1. Disconnect the No. 1 fuel vapor feed hose.



    A087574E01
  1. Disconnect the water by-pass hose.

  1. Disconnect the No. 2 water by-pass hose.



    A087575E01
  1. Disconnect the throttle control motor connector.

  1. Disconnect the throttle position sensor connector.



    A087583E01
  1. Disconnect the 3 wire harness clamps.

  1. Disconnect the connector clamp.

  1. Remove the bolt and harness clamp bracket.



    A087584E01
  1. Remove the No. 1 fuel vapor feed hose from the hose clamp.

  1. Remove the 3 bolts, 2 nuts and intake manifold.



    A087585E01
  1. Remove the gasket from the cylinder head.



8. REMOVE KNOCK SENSOR


A115481
  1. Disconnect the knock sensor connector.

  1. Remove the nut and sensor.