Home › ENGINE › 1NZ-FXE ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR SUPPORT OPENING COVER


A087414E01
  1. Remove the 6 clips and radiator support opening cover.



2. REMOVE ENGINE UNDER COVER LH


3. REMOVE ENGINE UNDER COVER RH


4. DRAIN ENGINE COOLANT
  1. Disconnect the coolant heat storage water pump connector.

  1. Connect a vinyl hose to the drain cock of the radiator.

  1. Connect a vinyl hose to the drain cock of the engine.

  1. Connect a vinyl hose to the drain cock of the coolant heat storage tank.

    CAUTION:
    If the tank has any malfunctions, the tank surface becomes hot. To prevent injuries from burns, do not touch the tank.

  1. Loosen the drain cock plugs of the radiator, engine and coolant heat storage tank, then drain the coolant.

    CAUTION:
    Even if the engine is cold, the coolant in the coolant heat storage tank is still hot. Be careful of the hot coolant when draining it.

    HINT:
    Record the amount of the drained coolant. It will be referred to when refilling the tank with coolant.



  1. Remove the radiator cap.


    A124655E01

  1. Drain the coolant in the radiator reservoir.



5. DRAIN HV COOLANT
  1. Remove the transaxle-side reserve tank cap.

    CAUTION:
    Do not remove the reserve tank cap while the engine is hot.



    C098375E01
  1. Remove the plug shown in the illustration and drain the coolant into a container.

  1. Install the plug with a new gasket.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }



6. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



7. REMOVE INVERTER WITH CONVERTER
  1. Remove the inverter with converter (Click here).



8. REMOVE CAMSHAFT POSITION SENSOR
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.