THROTTLE BODY > INSPECTION |
| 1. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY |
![]() |
Check the appearance.
Check that the throttle valve shaft does not rattle.
Check that each port is not clogged.
Check that the throttle valve opens and closes smoothly.
Check that there is no clearance between the throttle stop screw and lever when the throttle valve is fully closed.
![]() |
Inspect the resistance of the throttle control motor.
Using an ohmmeter, measure the resistance between the terminals.
![]() |
Inspect the resistance of the throttle position sensor.
Using an ohmmeter, measure the resistance between terminals 1 and 4.