Home › ENGINE › 1NZ-FXE COOLING › COOLANT HEAT STORAGE WATER PUMP

COOLANT HEAT STORAGE WATER PUMP > REMOVAL

for Preparation Click here



1. REMOVE REAR FLOOR NO. 2 BOARD


    A088353E01
  1. Unlock the 2 washer tank cover knobs, and then remove the rear floor board.



2. REMOVE REAR DECK FLOOR BOX


    A088354E01
  1. Remove the rear deck floor box from the vehicle.



3. REMOVE REAR FLOOR NO. 3 BOARD


    A088355E02
  1. Detach the 4 claws, and then remove the floor board.



4. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



5. REMOVE RADIATOR SUPPORT OPENING COVER


    A088174E01
  1. Remove the 6 clips and radiator support opening cover.



6. REMOVE FRONT WHEEL LH


7. REMOVE ENGINE UNDER COVER LH


8. REMOVE FRONT FENDER LINER LH
  1. Partially remove the front fender liner LH.



9. DRAIN ENGINE COOLANT (for Engine)
  1. Remove the transaxle-side reserve tank cap.

    CAUTION:
    Do not remove the reserve tank cap while the engine is hot.



    C098375E01
  1. Remove the plug shown in the illustration and drain the coolant into a container.

  1. Install the plug with a new gasket.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }



10. REMOVE COOLANT HEAT STORAGE WATER PUMP


A087332E01
  1. Disconnect the coolant heat storage water pump connector.

  1. Disconnect the 2 hoses.



    A087333E01
  1. Remove the bolt and coolant heat storage water pump.