Home › ENGINE › 1NZ-FXE COOLING › COOLANT HEAT STORAGE TANK

COOLANT HEAT STORAGE TANK > REMOVAL

for Preparation Click here


CAUTION:
  1. Before and after the procedure, be sure to check DTCs and confirm that no DTCs are output.
  2. If the tank has any malfunctions, the tank surface becomes hot. To prevent injuries from burns, do not touch the tank.
  3. The coolant heat storage tank assembly is prohibited from being disassembled and can be disassembled only as instructed.



1. REMOVE REAR NO. 2 FLOOR BOARD


    A088353E01
  1. Unlock the 2 washer tank cover knobs, and then remove the rear floor board.



2. REMOVE REAR DECK FLOOR BOX


    A088354E01
  1. Remove the rear deck floor box from the vehicle.



3. REMOVE REAR NO. 3 FLOOR BOARD


    A088355E02
  1. Detach the 4 claws, and then remove the floor board.



4. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



5. REMOVE RADIATOR SUPPORT OPENING COVER


    A088174E01
  1. Remove the 6 clips and radiator support opening cover.



6. REMOVE ENGINE UNDER COVER LH


7. REMOVE ENGINE UNDER COVER RH


8. REMOVE FRONT BUMPER COVER


B130316E01
  1. Put protective tape under the front fender.

  1. Using a clip remover, remove the 3 clips.

  1. Remove the 2 radiator grille protectors and 4 screws.

  1. Detach the 8 claws.



    B078079E02
  1. Detach the 4 claws and remove the bumper cover.

    1. Hold the front bumper cover on its upper and lower parts with your hands as shown in the illustration.

    2. Pull up the front bumper cover's lower part while holding its upper part securely.

      NOTICE:
      1. The claw will not disengage unless the front bumper cover's upper part is securely held.
      2. Do not forcibly pull up the front bumper. This will deform the claw.

  1. w/ Fog light:
    Disconnect the 2 fog light connectors.



9. REMOVE FRONT FENDER LINER LH
  1. Partially remove the front fender liner LH.



10. DRAIN ENGINE COOLANT (for Engine)


    A086936E01
  1. Loosen the drain cock plug, then drain the coolant.

    CAUTION:
    Even if the engine is cold, the coolant in the coolant heat storage tank is still hot. Be careful of the hot coolant when draining it.



11. REMOVE COOLANT HEAT STORAGE TANK ASSEMBLY


A087327E01
  1. Disconnect the 2 hoses.



    A086935E01
  1. Disconnect the water pump motor and temperature sensor connectors.



    A087328E01
  1. Remove the nut and 4 bolts.

    NOTICE:
    The coolant heat storage tank bracket can be easily bent. Hold the coolant heat storage tank tightly when removing the nut and bolts.



    A087329E01
  1. Separate the stud bolt and 2 claws shown in the illustration, then remove the coolant heat storage tank.