Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Smart Key System)

DTC    B1242    Wireless Door Lock Tuner Circuit Malfunction

for Preparation Click here


DESCRIPTION

This DTC is detected when a RDA signal is not input to the door control receiver through the certification ECU within 1 second after the main body ECU outputs a PRG signal.

DTC No.
DTC Detection Condition
Trouble Area
B1242
Within 1 second after PRG signal is output from body ECU during self-diagnostic mode, corresponding RDA signal is not input.
  1. Door control receiver
  2. Wire harness
  3. Certification ECU
  4. Driver side junction block (main body ECU)

WIRING DIAGRAM


B127175E03


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (DOOR CONTROL RECEIVER - CERTIFICATION ECU AND BODY GROUND)


    B127176E03
  1. Disconnect the D4 receiver connector.

  1. Disconnect the S11 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    D4-4 (DATA) - S11-10 (RDA)
    Below 1 Ω
    D4-3 (RSSI) - S11-11 (RSSI)
    D4-5 (+5) - S11-12 (RCO)
    D4-2 (GND) - Body ground
    D4-1 (GND) - Body ground
    D4-4 (DATA) or S11-10 (RDA) - Body ground
    10 kΩ or higher
    D4-3 (RSSI) or S11-11 (RSSI) - Body ground
    D4-5 (+5) or S11-12 (RCO) - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.CHECK WIRE HARNESS (CERTIFICATION ECU - MAIN BODY ECU AND BODY GROUND)


    B127177E03
  1. Disconnect the S11 and B7 ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    S11-29 (RDA3) - B7-23 (RDA)
    Below 1 Ω
    S11-28 (PRG) - B7-24 (PRG)
    S11-29 (RDA3) or B7-23 (RDA) - Body ground
    10 kΩ or higher
    S11-28 (PRG) or B7-24 (PRG) - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK DOOR CONTROL RECEIVER (OPERATION)
  1. Temporarily replace the door control receiver with a new or normally functioning one.

  1. Check that no DTC is output.

    OK:
    DTC is not output.



OK
END (DOOR CONTROL RECEIVER IS DEFECTIVE)
NG


4.CHECK CERTIFICATION ECU (OPERATION)
  1. Temporarily replace the certification ECU with a new or normally functioning one.

  1. Check that no DTC is output.

    OK:
    DTC is not output.



NG
REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU)
OK

END (CERTIFICATION ECU IS DEFECTIVE)