WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Smart Key System) > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the Techstream (with CAN VIM) to the DLC3.
Turn the power switch ON (IG).
Read the DATA LIST.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| D Door Courtesy SW | Driver side door courtesy switch signal / ON or OFF | ON: Driver side door is open OFF: Driver side door is closed | - |
| P Door Courtesy SW | Passenger side door courtesy switch signal / ON or OFF | ON: Passenger side door is open OFF: Passenger side door is closed | - |
| Rear Door Courtesy SW | Rear door courtesy switch signal / ON or OFF | ON: Either right or left door is open OFF: Both right and left doors are closed | - |
| D-Door Lock Pos SW | Driver side door lock position switch signal / ON or OFF | ON: Driver side door lock is in unlock position OFF: Driver side door lock is in lock position | - |
| Passenger Lock Pos SW | Passenger side door lock position switch signal / ON or OFF | ON: Passenger side door lock is in unlock position OFF: Passenger side door lock is in lock position | - |
| Rear Lock Position SW | Rear door lock position switch signal / ON or OFF | ON: Rear door lock is in unlock position OFF: Rear door lock is in lock position | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Key SW | Halfway switch signal / ON or OFF | ON: Key is in key slot. OFF: No key is in key slot. | - |
| PERFORM ACTIVE TEST |
Connect the Techstream (with CAN VIM) to the DLC3.
Turn the power switch ON (IG).
Perform the ACTIVE TEST according to the display on the tester.
| Tester Display | Test Part | Control Range |
| Hazard | Turns turn signal flasher relay ON / OFF | - |
| Trunk and Back-Door Open | Operate back door motor ON / OFF | - |
| Door Lock | Operate door lock motor for all doors OFF / LOCK / UNLOCK | All doors are closed |