STEERING SYSTEM > PRECAUTION |
| 1.HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM (SEE PAGE Click here) |
| 2.HANDLING PRECAUTIONS FOR STEERING COLUMN |
When handling the steering column assembly:
Avoid any impact to the steering column assembly, especially to the motor or the torque sensor. Replace with a new one if dropped or subjected to the severe impact.
Do not pull on the wire harness when moving the steering column assembly.
When the steering column assembly or other steering-related parts have been removed and either reinstalled or replaced, perform the steering center point adjustment (zero point calibration) (Click here).
When disconnecting and reconnecting the connectors:
When disconnecting the connector related to the electronic motor power steering system, turn the power switch ON (IG), center the steering wheel, turn the power switch off, and then disconnect the connector.
When reconnecting the connector related to the electronic motor power steering system, turn the power switch OFF, Center the steering wheel, and then turn the power switch ON (IG) before reconnecting the connector.
If the procedures above are not perform properly, the steering center point (zero point) will deviate, which will lead to a difference in steering effort between right and left. If there is a difference in the steering effort between right and left, perform the steering center point adjustment (zero point calibration) (Click here).
| System Name | See Page |
| Power Window Control System |
Click here
|