STEERING COLUMN ASSEMBLY > REASSEMBLY |
| 1. INSTALL POWER STEERING MOTOR ASSEMBLY |
Secure the steering column in a vise so that the motor installation part is horizontal.
Apply MP grease to the serrated part of the motor and install it to the steering column.
![]() |
Using SST, turn the steering main shaft 2 or 3 turns at a rate of one turn per second to seat the motor, and temporarily tighten the 2 bolts.
Fully tighten the 2 bolts.
![]() |
Hold the wire harness for the power steering motor and torque sensor wire harness with the 2 clamps and vinyl tape as shown in the illustration.