TRANSMITTER BATTERY > INSTALLATION |
| 1. INSTALL TRANSMITTER BATTERY |
![]() |
Install a new battery (lithium battery: CR1632) with the positive (+) side up, as shown in the illustration.
Check that the O-ring is not distorted or slipped off, and install the cover.
Install the 4 screws.
![]() |
Push and hold the release knob in the direction indicated by the arrow labeled A. Push in the slide cover in the direction indicated by the arrow labeled B and install the slide cover.
![]() |
Push and hold the release knob in the direction indicated by the arrow. Insert the emergency key into the case.